What did you do to your Ranger today?

[RRTruuck]

Installed some N-fab steps. Only thing I don't like is the ends are wide open. Need to find some caps or plugs for them so they don't fill up with crap from the road.

Sponsored

 

[TVRangerSTX]

Installed some N-fab steps. Only thing I don't like is the ends are wide open. Need to find some caps or plugs for them so they don't fill up with crap from the road.

in the meantime shoot some spray foam in there?

 

[bdtairgard]

Installed Rough Country pocket flares.

 

[Dr3wDrop]

in the meantime shoot some spray foam in there?

I think I have seen before the spray foam will actually hold in moisture worse than nothing.

 

[Doc]

I think I have seen before the spray foam will actually hold in moisture worse than nothing.

Yup, it happened in one of my boats, rotted the floors.

 

[TVRangerSTX]

Yup, it happened in one of my boats, rotted the floors.

OK bad idea, forget I said that!

 

[RedDakooter05]

OK bad idea, forget I said that!

Just poke a small hole in the bottom of the dried foam "cap" and periodically shoot some fluid film/krown/whatever in to the tube through said drain hole.

 

[armoredpig]

Big fan of how pushed out these ditch lights sit on the sdhq brackets. Redid my ditch lights with these auxbeam triangular lights. More spot vs flood than ideal for a ditch light, but they're great for hostile drivers ?

 

[Cabose-1]

Installed some N-fab steps. Only thing I don't like is the ends are wide open. Need to find some caps or plugs for them so they don't fill up with crap from the road.

Mine had plugs on the end. Then one day noticed rust on my garage floor. I Naturally freaked out because the ranger was new. Found the plugs kept water in. So thought about drilling holes on the bottom. Ditched that idea and took the plugs off. Figured id rather have air flowimg through them to keep humidity out and hopefully dry them if any water was stored in there. And if mud collects on the inside, hopefully it was dried out through the air flowing througg them as i drove. Haven't had any rust on the garage floor since then. So hopefully its working

 

[Venom_z89]

Installed some N-fab steps. Only thing I don't like is the ends are wide open. Need to find some caps or plugs for them so they don't fill up with crap from the road.

Get on Amazon and look for tube plastic caps that have same id as your side steps. They'll probably be advertised as fence post caps or something along the lines. They'll look similar to the plastic rivets that hold all the plastic moldings on our truck.

 

[vreg]

i changed the wheel of my ranger ..

 

[Glocker]

F--- me! I've never had an issue with this and now I'm hitting it all the time. I'm 6'3". This has never been a problem until now. Damn it!

So, I think I'm hitting this when I get in or out of the truck. Not while I'm driving it.

 

[IdahoRanger]

Got "The Works" done.

 

[OrangeStreak]

Did the annual Damper Maintenace scheduled service today (2 seconds)...please ignore the deteriorating hand? (atrophy from Damper use) ?

KOOL DAMPER KLUB member since Jan, 2022

 

[Zeroedin]

i changed the wheel of my ranger ..

Ok, I gotta ask…..which wheel did you change? I mean, did you have a flat, or did you swap the steering wheel out or get new wheels all around?

Sponsored