Just updated to Sync 3.4 on my Ranger 2019

[NedKelly]

Out of curiousity, does anyone have a pic of what the 3.4 home screen looks like?

Sponsored

 

[RCMUSTANG]

Out of curiousity, does anyone have a pic of what the 3.4 home screen looks like?

Posted in my build thread.

 

[NedKelly]

Posted in my build thread.

Thanks!

 

[Hambone437]

I’m going for it!! I downloaded and updating 3.4 as I type this. I have my truck connected to a 6amp battery tender. I hope it keeps the truck on through the update.

 

[Dmax]

I’m going for it!! I downloaded and updating 3.4 as I type this. I have my truck connected to a 6amp battery tender. I hope it keeps the truck on through the update.

Good luck!!! Hope it all works out. Keep us posted!

 

[BHunted]

Still at 3.3 with no notices yet... Good luck....

 

[Hambone437]

Success!!! So far everything works as expected. sync 3.4 and map 1.18

 

[Snorebaby]

I’m going for it!! I downloaded and updating 3.4 as I type this. I have my truck connected to a 6amp battery tender. I hope it keeps the truck on through the update.

Did you have the charger set on 6amp? I have an older 2amp/6amp charger and want to use it to do the update.

 

[Hambone437]

Did you have the charger set on 6amp? I have an older 2amp/6amp charger and want to use it to do the update.

I had it set to 6amps. The update took just over 30 minutes. The update has a timer on the screen counting the minutes for you. Glad I was sitting in the truck right when it completed because it only gave a few seconds warning that the update was complete and you need to remove the USB as it restarts on its own.

 

[Andy]

Success!!! So far everything works as expected. sync 3.4 and map 1.18

Any noticeable speed improvement? Any issues?

 

[UofMEngineer]

Success!!! So far everything works as expected. sync 3.4 and map 1.18

Since you're already there, update to 19274 apps and core voice files like the others. It's quite a bit better overall from 19101.

 

[Hambone437]

Any noticeable speed improvement? Any issues?

Everything was working without a glitch, including Apple CarPlay. However, after backing out of a parking spot leaving the store, the rear view camera displayed normally except when I would get up to speed (I had the rear camera set to delay) I would get a blue screen. The only way to clear the blue screen is to select the X at the upper left of the screen. I tried reverse repeatedly with the same results.

If I switch to Park, the blue screen goes away on its own. I turned off the camera delay and that eliminated the blue screen between park and drive. It’s just when I have the camera delay turned on that when I switch from reverse to drive and reach the speed that turns the rear camera off, I get a solid blue screen. Bummer! Anyone have any ideas?

 

[Hambone437]

Since you're already there, update to 19274 apps and core voice files like the others. It's quite a bit better overall from 19101.

Done. My build is now 19274. Still having a rear camera issue

 

[Hambone437]

Out of curiousity, does anyone have a pic of what the 3.4 home screen looks like?

This was 3.4 after updated from 3.3

 

[Tony Giordano]

This was 3.4 after updated from 3.3

Just curoius, what steps did you follow? Going to try this tonight if I can.

Sponsored